| panel_width: | | panel width: |
| panel_height: | | panel height: |
| corr_period: | | corrugation period, the width of one sequence of up-rib-down-rib: |
| corr_height: | | corrugation crown height, measured from the center of the undulations: |
| corr_radius: | | corrugation crown radius, how rounded is the crown peak: |
| corr_rounding: | | corrugation peak rounding quality, how many points are used to make the curve. Set to 1, makes flat peaks. 0 is invalid, reverts to 1: |
| corr_thick: | | corrugation thickness (if 0, then panel_thick is used to make a backing: |
| panel_thick: | | panel thickness (0 = no panel, just corrugation): |
| modeling_scale: | | The modeling scale of the .stl file. Specifies the denominator of the scale, e.g., 1/87 for HO scale, the default. Assumes the dimensions specified in the previous parameters are prototype, e.g. 1:1. |
| printing_scale: | | Scales the model for printing. Default is 25.4, the multiplier to convert decimal inches to millimeters: |
| filename: | | Enter a name to use for your .stl file, minus the .stl extension. |